• SPEC SHEET
• PARTS DIAGRAMS /
  OPERATOR'S MANUAL
• LARGER IMAGES

Model 186

Model 184

Adjustable Below-Hook Drum Carriers

  500 Lb. (227 kg) Capacity

Morse Adjusto-Karriers lift, rotate and control the pour of a drum at or above your reach.

Morse Adjusto-Karriers enable you to pour a fiber or steel drum or cylinder above your reach. They adjust to a range of diameters and allow you to control drum tilting 360 in either direction. Rubber faced grip pads are tightened by hand-crank to fit drum diameter. Dispense drum contents with your hoist or crane. These drum carriers have a pull chain to control the drum tilt with a 30:1 gear and sprocket ratio. Gears are covered.

• Model 186 for 15" to 23" (38.1 to 58.4 cm) diameter containers
• Model 184 for 8" to 15" (20.3 to 38.1 cm) diameter containers

Capacity:

• Full drum up to 500 Lb. (227 kg)
• Half-full drum* up to 250 Lb. (114 kg)

Every Morse Below-Hook Drum handler is load tested at the factory as per American National Standard ASME B30.20 and a load test certificate is enclosed with each unit.

Available with optional

Select Model #

Half-Full Drum Rating

* Half-Full Drum Rating is an indication of capacity for tilting unbalanced, bottom-heavy drum. Partially full drum with unbalanced and shifting load is harder to tilt than full drum.

Morse below-the-hook drum lifters

IMPORTANT - It is critical to use the correct holder and accessory to lift your drum type and dimensions.

Morse below-the-hook drum lifters are manufactured by Morse Mfg. Co., Inc. in East Syracuse, NY 13057. These drum lifters comply with ANSI/ASME B30.20 standard for mechanical, below-the-hook lifting devices as it applies to the following:

• Rated load markings and unit identification
• Minimum design safety factor of 3, based on yield strength, for load bearing structural components
• Welding is performed by certified welders who have passed the ANSI/AWS D14.1 welding qualification test

Last Updated: 11/29/11

Adjustable below-hook drum carriers with 500 Lb. (227 kg) capacity to tilt and pour drum below-hook with hoist or crane - Morse Adjusto-Karriers. More than just a drum inverter or drum dumper... ...drum carriers for controlled Drum Dispensing.