Morse Tilt-To-Load Drum Tumblers

Drum Rotators - "Corner-Over-Corner" Drum Tumblers

Morse Tilt-To-Load Drum Rotators have power-lift, and tumble drum "corner-over-corner" to thoroughly mix contents. The drum tumbler holds your drum on an angle to rotate drum with vigorous "corner-over-corner" action!

Drum Holder on
Tilt-To-Load Drum Tumblers
supports your drum with base plate under drum, 2 clamps at top of drum and cinch chain around drum.

Drum Tumblers Save Time, Labor and Money! Mix right inside your closed drums. Ergonomic power-tilt for easy floor-level loading. Second control to start and stop drum tumbling.

Use your Drum Tumbler to rotate a steel, plastic or fiber drum

• Tumble drum 29" to 37" (74 to 94 cm) tall
• Tumble drum 18" to 23.5" (46 to 60 cm) in diameter
• Variable speed: 5 to 20 RPM
• Capacity:
  • 800 Lb. (363 kg) full drum
  • 400 Lb. (181 kg) half-full drum*
• Motor is 2 HP, 60 Hz.
• Drum tumbler dimensions

Options and Upgrades

1. Enclosure with Safety Interlock
2. Safety Enclosure with Automatic Control Package

Easy to Load by Hand truck or Hoist without the hazards of manual drum handling

Quick and Simple Drum Tumbler Operation

1. Quickly load upright drum into the Tilt-To-Load Rotator at floor level with drum truck, Model 81 Drum Spotter or hoist attachment (shown loading with Model 160-WP 4-Wheel Drum Truck).

2. Secure your drum in drum rotator using the cinch chain around drum and two top clamps

3. Turn motor on to activate drum tumbler hydraulics

4. Tilt drum to top position with RAISE control valve

5. Begin drum rotation with the ROTATE control valve

Install all Morse Rotators in accordance with OSHA requirements for enclosure and safety interlock, etc. Drum rotator must automatically turn off when enclosure door is opened.

Options for your Tilt-To-Load Drum Tumbler

1. Enclosures with Safety Interlock to automatically shut off the drum tumbler when the enclosure is opened.
2. Safety Enclosures with Automatic Control Package allow you to load the drum, close the enclosure, set the rotation time, and walk away. The rotator will automatically lift the drum, rotate for the time you set, then lower the drum to upright at floor-level for easy access.

Outside post-to-post Dimensions: L88” x W52” x H74” (224 x 132 x 188 cm)

For OSHA compliance, see OSHA subpart O.1910.212(a)(4) "Barrels, containers, and drums. Revolving drums, barrels, and containers shall be guarded by an enclosure which is interlocked with the drive mechanism, so that the barrel, drum, or container cannot revolve unless the guard enclosure is in place."

Power connections and motor controls must comply with applicable codes.